INSTALL: APEXi turbo timer

[trinydex]

http://forums.evolutionm.net/showthread.php?t=75679


Here's a quick run down on the install of my apexi tt. It would help to become familiar with the Evo ECU pinout before beginning. RRE has been nice enough to host this on their website and it can be found here, ECU Pinout (http://www.roadraceengineering.com/evo/tech/EVO-ecuwiring.htm) The two pins we are concerned with is the Chassis Ground on pin 26 and the Front O2 Sensor on pin 76.

Click here for Pics and how to. (http://forums.evolutionm.net/showthread.php?t=75679)

First you have to take the glove box out.

http://www.socalevo.net/gallery/albums/userpics/10991/mURI_temp_264c619c.jpg


Just take out the little clip on the left side of the glove box. Just slide it foward to pull it out. Then push out the other stop on the right side and drop the box all the way down and drop it out.


Next pull the bottom cover plate out foward.

http://www.socalevo.net/gallery/albums/userpics/10991/mURI_temp_49bcf56d.jpg


Here is the ecu plugs. The ground goes on the first plug on the left and the o2 wire goes on the last plug on the right.

http://www.socalevo.net/gallery/albums/userpics/10991/mURI_temp_0a9a3b37.jpg


Here is where the ground connects. It is the very last black wire on the bottom right of the first connector. You can use the pink quick connects for an easy install for these wires. Make sure that you clamp the metal piece all the way down for a good connection.

http://www.socalevo.net/gallery/albums/userpics/10991/mURI_temp_c636e6b2.jpg


Next is the o2 voltage wire. It is the white wire located on the last connector. It is on the top row 6 pins in beginning with the first pin and counting to the right.

http://www.socalevo.net/gallery/albums/userpics/10991/mURI_temp_4f92b371.jpg


Here is where I mounted mine for easy viewing of afr's and o2 readings. I used double sided tape to mount it. :D

http://www.socalevo.net/gallery/albums/userpics/10991/mURI_temp_df9ea038.jpg