PDA

View Full Version : timing belt tensioning tool


EVO GRIM
04-03-2005, 07:46 PM
Where do I get a timing belt tensioning tool?
BSREVO
04-03-2005, 08:50 PM
http://forums.evolutionm.net/showthread.php?t=129111&highlight=timing+belt+tool
EVO GRIM
04-03-2005, 09:07 PM
Thx. I'm looking at instaling cam gears.

http://www.streetracing.org/home.php?op=view&id=1072&pg=

This how to is for cams and gears. Can somebody tell me if you need the engine at top dead center to just change cam gears? Seems to me as long as you get them back in the same spot they dont need to be at tdc. Saves me from pulling the spark plugs and turning the engine over.
Dr. Evo
04-05-2005, 09:49 PM
Wityh the timing cover off you can find TDC the right way. BE VERY CAREFUL AS A FEW TEETH CAN FUCK UP THE ENGINE!!
EVO GRIM
04-06-2005, 07:09 PM
But I can swap out the cam gears if i'm care full to mark where the "zero" tooth goes, with out cranking the engine to tdc?
Dr. Evo
04-06-2005, 08:47 PM
So you are not planning on taking the belt completely off?
DRFTR8
04-07-2005, 12:35 AM
you might need this to help you out with your install...
CAM & GEAR INSTALL (http://www.evomoto.com/tech_info.php?tPath=3_6&tech_id=18)
EVO GRIM
04-07-2005, 06:59 AM
No I'm thinking of just taking one gear out at a time, very carefuly.