redvolution
03-20-2010, 07:53 AM
$550. located in NorCal, will ship at buyer's expense
This splitter was designed as big as possible within the NASA TT rules (in 2008). It provides noticeable downforce above 70mph and especially in braking. It sits 2.5-3" from the ground but could be raised. To attach to stock Evo 8/9 bumper, remove the factory lip and drill holes for nutserts. Screws then thread through holes in the top of the splitter's air dam and into the nutserts in the factory bumper. Note the brake cooling ducts and NACA ducts for tranny and t-case cooling.
Nothing short of a full Voltex bumper+undertray will equal the downforce of this piece. It was built by Brian Lock out of alumalite - the whole splitter only weighs about 15lbs.
I only ran it 1 time at Infineon - with 300whp and 255 R888s I did a 1'51.x. To equal that time without it I needed 345whp.
http://cracknut.smugmug.com/photos/417428677_87DE7-L.jpg
http://cracknut.smugmug.com/photos/417428356_bWZHm-L.jpg
http://cracknut.smugmug.com/photos/417428558_2HrRD-L.jpg
http://cracknut.smugmug.com/photos/417428597_i97nQ-L.jpg
extra mount point on car uses optional welded tab (not necessary):
http://cracknut.smugmug.com/photos/417435318_XZAyb-L.jpg
quick release for attaching to mount point above:
http://cracknut.smugmug.com/photos/417435209_QZtzi-L.jpg
This splitter was designed as big as possible within the NASA TT rules (in 2008). It provides noticeable downforce above 70mph and especially in braking. It sits 2.5-3" from the ground but could be raised. To attach to stock Evo 8/9 bumper, remove the factory lip and drill holes for nutserts. Screws then thread through holes in the top of the splitter's air dam and into the nutserts in the factory bumper. Note the brake cooling ducts and NACA ducts for tranny and t-case cooling.
Nothing short of a full Voltex bumper+undertray will equal the downforce of this piece. It was built by Brian Lock out of alumalite - the whole splitter only weighs about 15lbs.
I only ran it 1 time at Infineon - with 300whp and 255 R888s I did a 1'51.x. To equal that time without it I needed 345whp.
http://cracknut.smugmug.com/photos/417428677_87DE7-L.jpg
http://cracknut.smugmug.com/photos/417428356_bWZHm-L.jpg
http://cracknut.smugmug.com/photos/417428558_2HrRD-L.jpg
http://cracknut.smugmug.com/photos/417428597_i97nQ-L.jpg
extra mount point on car uses optional welded tab (not necessary):
http://cracknut.smugmug.com/photos/417435318_XZAyb-L.jpg
quick release for attaching to mount point above:
http://cracknut.smugmug.com/photos/417435209_QZtzi-L.jpg