View Full Version : turbo timer install (help)
brwnrice
03-22-2004, 07:18 PM
okay, looking at RRE's ecu pinout diagram ecu wiring diagram (http://www.roadraceengineering.com/evo/tech/EVO-ecuwiring.htm) i can not find the O2 sensor signal and the engine ECU ground wire. in order to fully utilize my apexi turbo timer i have to locate both of these. anybody care to help?
EvolvedDSM
03-22-2004, 07:28 PM
#76 is the sensor wire you want. Any bare metal point should work for your ground or you could use #13 or #26.
brwnrice
03-22-2004, 07:32 PM
cool! thanks for the fast response. *runs to the garage*
BluEvo
03-23-2004, 01:15 AM
hey brwnrice,
u picked up one of those too. i just installed mines yesterday. :) i have to get some stronger double sided tape though. it doesn't stick very well. thinking about using velcro adhesive so, it can be easily removed or repositioned.
chris
03-23-2004, 08:48 AM
velcro works better =). thats what i use.
BluEvo
03-23-2004, 01:07 PM
velcro works better =). thats what i use.
:thumbsup:
EvOlUtIoN_IX_SE
02-24-2007, 05:16 PM
is this set up for the evo ix?
vtluu
02-24-2007, 06:06 PM
Look at the heading on the first post:
turbo timer install (help)
« on: 2004-03-22, 18:18:03 »
Since there were no Evo IX's in 2004, that would be a "no". :lol:
Good for you for searching, though. :thumbsup:
dohcvtec
02-24-2007, 06:06 PM
Dude, this thread is from 2004, the evo ix did not exist yet.
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.