EFIxMR
06-13-2006, 07:49 PM
Stayed up extra late last night working on a project and just thought id share some of my results...
http://www.speedelement.com/images/welding/misc/scraps.jpg
left overs
http://www.speedelement.com/images/welding/misc/bandsaw.jpg
cut pipes not fingers
http://www.speedelement.com/images/welding/misc/dynasty.jpg
R2 can you hear me?
http://www.speedelement.com/images/welding/misc/gticpipe.jpg
many man hours later
http://www.speedelement.com/images/welding/misc/bov%20weld.jpg
not the best aluminum welding I've done, but it will do
http://www.speedelement.com/images/welding/misc/beadrolled.jpg
bead rolled for high boost. no popped couplers here *cross fingers*
http://www.speedelement.com/images/welding/misc/dp.jpg
My custom full 3 inch SS downpipe with vband clamp off my 16G setup. Clears all bars and 05' ACD. Debating on if i should get it massed produced. By the looks of it... Not sure if a machine could duplicate something that intricate in terms of bends and angles.
http://www.speedelement.com/images/welding/misc/dpfull3inch.jpg
Full 3 inch from the flange. ID of the 3 inch pipe is maintained the entire way thru. I remember Bryan saying in the classifieds, no dp pipe was a true 3 inch. Well this one is!
http://www.speedelement.com/images/welding/misc/TBE.jpg
Here's my 3 inch exhaust. It is really quiet considering my crazy cams.
http://www.speedelement.com/images/welding/misc/scraps.jpg
left overs
http://www.speedelement.com/images/welding/misc/bandsaw.jpg
cut pipes not fingers
http://www.speedelement.com/images/welding/misc/dynasty.jpg
R2 can you hear me?
http://www.speedelement.com/images/welding/misc/gticpipe.jpg
many man hours later
http://www.speedelement.com/images/welding/misc/bov%20weld.jpg
not the best aluminum welding I've done, but it will do
http://www.speedelement.com/images/welding/misc/beadrolled.jpg
bead rolled for high boost. no popped couplers here *cross fingers*
http://www.speedelement.com/images/welding/misc/dp.jpg
My custom full 3 inch SS downpipe with vband clamp off my 16G setup. Clears all bars and 05' ACD. Debating on if i should get it massed produced. By the looks of it... Not sure if a machine could duplicate something that intricate in terms of bends and angles.
http://www.speedelement.com/images/welding/misc/dpfull3inch.jpg
Full 3 inch from the flange. ID of the 3 inch pipe is maintained the entire way thru. I remember Bryan saying in the classifieds, no dp pipe was a true 3 inch. Well this one is!
http://www.speedelement.com/images/welding/misc/TBE.jpg
Here's my 3 inch exhaust. It is really quiet considering my crazy cams.