I doubt the OBDII scanner would pick anything up...I'll confirm it when Bryan retunes my car.Originally Posted by MarkSAE
I doubt the OBDII scanner would pick anything up...I'll confirm it when Bryan retunes my car.Originally Posted by MarkSAE
Evo Green w/upgraded WGA 18psi
Helix O2 Housing
Helix Downpipe
Perrin Test Pipe
HKS Hi-Power Exhaust
AEM ShortRam Intake
Ported/Polished/Coated stock manifold
Ported turbine housing
HKS 280 intake/exhaust
Vishnu cam gears -3/-3
GM 3 port solenoid
Turbohoses Intercooler/UICP
ETS version 2 LICP
ACT HDSS Clutch
Walbro 255lph
RC 1200cc injectors
Sun Hyperforce
Mil Spec 65mm Throttle Body
Zeitronix ZT-2 LCD & ZAVT-1
400awhp on E85 tuned by Bryan @ GST
Bryan, I need to get this ASAP... my evo is getting close to it's first smog checkOriginally Posted by bryan@GST
Code:sub<br />b{[@b=(abs||No,bottle.”s”x!!++$_,of,beer),on,the,wall]}print<br />“@{+b},\n@b,\nTake one down, pass it around,\n@{+b}.\n”<br />for-pop||-99..-1
I am dreading that day. Will have to remove some stuff and maybe get a retune if I don't have something from the earlier CB Tuning days. Is it possible to get a new flash that will pass smog? I have no idea what to expect here.Originally Posted by chrisw
for the most part I think I am ok. I have a new-ish EVO IX cat and I am certain that I can get my idle stable enough for the test.
I suspect that with our cars, you just have to make sure you have a nice conservative tune under 3000 rpm...
Code:sub<br />b{[@b=(abs||No,bottle.”s”x!!++$_,of,beer),on,the,wall]}print<br />“@{+b},\n@b,\nTake one down, pass it around,\n@{+b}.\n”<br />for-pop||-99..-1
Good question, I'll put it on my Evo and see if the readiness test works.Originally Posted by MarkSAE
You are going to try to pass the smog test with those M3 cams?Originally Posted by chrisw
whats the advantage of 3d knock control?
Reduce or Increase knock sensor sensitivity at any rpm and loadOriginally Posted by leaveit2bevo
Great for built motors, noisey trans and clutches, etc
I think this was the final "Stand-alone can do better" factor. In fact the factory knock control system is miles better than most stand alones.
Lemme know how it goes since we both have the same year.Originally Posted by bryan@GST
This ROM mod works great. Usually I get the code while crusing on the freeway or driving through a parking lot. Nothing yet... no pending codes either.
I believe mrfred "fixed" the issue.
Tuned by Bryan@GST Motorsports
557whp / 441wtq @ 32 psi - E85
493whp / 372wtq @ 28 psi - 91 octane & 50/50 meth/water
415whp / 317wtq @ 23 psi - 91 octane
«·• no mods, just ninjas •·»